Sandcraft Motorsports Carrier Bearing For Maverick X3 Models
This Patented Maverick X3 Carrier Bearing Provides the ability to Provide the Correct Angles for your Driveline with Self Adjusting. No imitations.
Their innovative, Patent pending, Carrier Bearing assembly!
Designed with off-roading in mind, it improves the driveline angle and raises the height for more ground clearance.
Providing your UTV the long term longevity you want & deserve.
Fully Sealed Bearing & Fully Greaseable
We have created and patented this design to be a GREASABLE bearing while having 3 layers of protection to keep dirt, sand, mud, and water out.
Patented Design, Sandcrafts Auto Set Angle self-aligning bearing reduces side load on your carrier bearing from the prop-shaft – a must have if you want to keep vibrations to a minimum and the life of your bearing long.
Our all new auto set angle & 2 piece design will lower installation time dramatically, It allows you to press the bearing onto the shaft and install with minimal effort.
Side loading the bearing leads to pre-mature wear and failure. The auto set angle eliminates this from happening to your car.
We are the ONLY COMPANY in the world with this design so don’t waste your time with the copycats.
Add On Grease Whip
Add Grease Whip
- IF YOU OWN OUR GEN3 CARRIER BEARING THIS NEW GREASE WHIP IS A MUST HAVE!!!
- Do you like that you can service your GEN3 carrier bearing, but dread crawling under your RZR to remove the skid plates to access the carrier?
- Problem solved!!! Just insert the grease tube into the carrier bearing and you can run the whip right through your center console!
- *FITS ALL SANDCRAFT CARRIER BEARINGS
Learn More About Sandcraft Motorsports:
What others are saying
There are no contributions yet.