Polaris RZR XP 1000 Carrier Bearing

Sandcraft Motorsports RZR XP 1000 Gen 3 Carrier Bearing

Sandcraft’s Patented RZR XP 1000 Carrier Bearing that provides the ability to provide the correct angles for your driveline with self adjusting

Sandcraft Motorsports is the Pioneer to this solution that reduces vibration & chattering. Their innovative, Patent pending, Carrier Bearing assembly! Designed with off-roading in mind, it improves the driveline angle and raises the height for more ground clearance. Providing your UTV the long term longevity you want & deserve.

Fully Sealed Bearing & Fully Greaseable

We have created and patented this design to be a GREASABLE bearing while having 3 layers of protection to keep dirt, sand, mud, and water out.

Self-Aligning Bearing

Patented Design, Sandcrafts Auto Set Angle self-aligning bearing reduces side load on your carrier bearing from the prop-shaft – a must have if you want to keep vibrations to a minimum and the life of your bearing long.

Our all new auto set angle & 2 piece design will lower installation time dramatically, It allows you to press the bearing onto the shaft and install with minimal effort.

Side loading the bearing leads to pre-mature wear and failure. The auto set angle eliminates this from happening to your car.

We are the ONLY COMPANY in the world with this design so don’t waste your time with the copycats.

Add On Race Collar:

With the stock driveline your vehicle is using a slip yoke at the rear transmission output shaft.

The motor is rubber mounted which is loading the driveline while under aggressive driving conditions.

The driveline is designed with a pressed fit bearing onto the stock carrier bearing shaft.

In extreme conditions it will pull out and disable 4-wheel drive capabilities.

Our racer driveline collar can be used with the stock carrier bearing but is HIGHLY recommended with our upgraded GEN 2 and Gen 3 carrier bearing.

Learn More About Sandcraft Motorsports: